Post - Knowmats

Using an Intermediate Validation Step to Increase CAE Confidence

May 24, 2016 | by DatapointLabs | views 5907

Simulations contain assumptions and uncertainties that a designer must evaluate to obtain a measure of accuracy. The assumptions of the product design can be differentiated from the ones for the solver and material model through the use of a mid-stage validation. An open loop validation uses a controlled test on a standardized part to compare results from a simulation to the physical experiment. From the validation, confidence in the material model and solver is gained. In this study, the material properties of a polypropylene are tested to characterize for an *ELASTIC *PLASTIC model in ABAQUS. A validation of a quasi-static three-point bending experiment of a parallel ribbed plate is then performed and simulated. A comparison of the strain fields resulting from the complex stress state on the face of the ribs obtained by digital image correlation (DIC) vs. simulation is used to quantify the simulation's fidelity.

Christoper Wolfrom*, Megan Lobdell and Hubert Lobo.

*Cornell University

Presented at Science in the Age of Experience, Boston, MA; May 23-25, 2016.